1994 Chrysler LHSFACTORY OEM SERVICE PROCEDURE

Test 36A - Identifying Remote Keyless Entry (RKE) Problem

NOTE: Perform TEST VER-1  after each repair.
  1. Lower both front windows. Remove key from ignition switch. Close all doors. Lock and unlock doors from both front door switches. If doors fail to lock or unlock properly, perform appropriate test listed in the TEST 36A DIAGNOSTIC DIRECTORY  . If doors lock and unlock properly, go to next step.
    TEST 36A DIAGNOSTIC DIRECTORY

    Problem Perform Test No.
    Left Front Door Fails To Lock & Unlock From Any Switch TEST 36B 
    Left Front Door Fails To Lock From Any Switch TEST 36C 
    Left Front Door Fails To Unlock From Any Switch TEST 36D 
    All Doors (1) Fail To Lock & Unlock TEST 36E 
    All Doors (1) Fail To Lock TEST 36F 
    All Doors (1) Fail To Unlock TEST 36G 
    (1) Except left front door.
  2. Using Remote Keyless Entry (RKE) transmitter, operate door locks and trunk lock. If door locks and trunk lock do not operate properly, replace transmitter batteries or substitute a known-good transmitter. If RKE transmitter still does not operate properly, go to TEST 36H  . If RKE transmitter operates properly, go to next step.
  3. Insert key in ignition switch. Open left front door. Lock doors from either switch. If doors lock with key in ignition switch, go to TEST 35J in TESTS W/CODES - BODY CONTROL COMPUTER article in the ENGINE PERFORMANCE Section. If doors do not lock with key in ignition switch, go to next step.
  4. If vehicle is equipped with speed sensitive locks, drive vehicle with all doors closed. Reach a vehicle speed more than 15 MPH. If doors do not lock at more than 15 MPH, go to TEST 35K in the appropriate TESTS W/CODES - BODY CONTROL COMPUTER article in the ENGINE PERFORMANCE Section. If doors lock, system is operating properly at this time.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.