Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Chrysler LHSFACTORY OEM SERVICE PROCEDURE
Keyless Entry System - Remote: Testing: Notes
NOTE:
The Remote Keyless Entry (RKE) system is connected to the Body Control Computer system. Testing of the RKE System requires use of the Chrysler Diagnostic Readout Box (DRB) tester to check circuits connected to the Body Control Computer. Only those specific tests for the RKE system are included here. See TESTS W/CODES - BODY CONTROL COMPUTER
article in the ENGINE PERFORMANCE Section for complete Body Control Computer testing.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.