Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Chrysler ImperialFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| ABS Control Module | Under battery, or in trunk, next to right speaker. |
| Air Bag Diagnostic Module | Behind center console, near floor. |
| Air Suspension Control Module | On right side of trunk, behind trim panel. |
| ATC Power Module | Behind right side of dash, on A/C-heater case. |
| Auto. Level Control Module | In right rear corner of trunk. |
| Body Control Module (BCM) | Behind right kick panel. |
| Electronic Controlled Automatic Transaxle (ECAT) Controller | In engine bay, on right inner fender panel. |
| Engine Bay Node Module | On front of radiator closure panel. |
| Keyless Entry Module | Behind dash, above glove box. |
| Light Outage Module | Behind dash, above glove box. |
| Memory Seat Module | Under driver seat. |
| Powertrain Control Module (PCM) | At left front corner of engine bay. See Figure . |
| Security Alarm Module | Behind dash, above glove box. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
