Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Chrysler ImperialFACTORY OEM SERVICE PROCEDURE
Code No. 22 (Control Module Error)
If Code No. 22 occurs, control module has identified out-of-range data. Replace ATC control panel. See ATC CONTROL MODULE/CONTROL PANELΒ under REMOVAL & INSTALLATION.
NOTE:
Failure Codes 23-28 are set during normal ATC operation. ATC system must be in operation for 15 minutes before these codes will set. ATC control module will compensate for feedback failures immediately during power up. Codes will not be set before 15 minutes. Codes are then stored in memory and must be erased. See EXITING DIAGNOSTIC MODEΒ under TESTING.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
