Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Chrysler ImperialFACTORY OEM SERVICE PROCEDURE
Memory Control Module
- Remove seat assembly from vehicle. See SEAT ASSEMBLYΒ .
- Lay seat on its back on a clean surface.
- Remove screws attaching control module to seat track. See Figure .
- Disconnect control module wiring.
- Remove control module.
- To install, reverse removal procedure. Set system soft limits by performing the memory seat diagnostic self check, so that the control module will learn the soft limits of the assembly. See SYSTEM SOFT LIMITSΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
