Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Chrysler ImperialFACTORY OEM SERVICE PROCEDURE
DRB-II Test Functions: Notes
NOTE:
DO NOTÂ
touch DRB-II keypad during DRB-II power-up sequence or an error message will result.
- In order to perform diagnostic tests using the DRB-II, the DRB-II must be in the ABS MENU. At the ABS MENU, fault codes and DRB-II test functions can be accessed.
- To reach ABS MENU, turn ignition off. Attach DRB-II to Chrysler Collision Detection (CCD) bus diagnostic connector. Connector is located under driver's side of instrument cluster. Turn ignition switch to RUN position.
- All DRB-II character positions will illuminate and copyright information will appear on screen for a few seconds. If the DRB-II screen display is blank or if any error messages appear, refer to DRB-II PROBLEMS & ERROR MESSAGESÂ .
- After a few seconds, the DRB-II menu will appear. At DRB-II menu, press "4" (SELECT SYSTEM) key to enter diagnostic test program. Press down arrow 3 times to change menu display.
- Select "5" (ABS) key to enter ABS part of the DRB-II program. After a few seconds, the ABS MENU will appear. The screen will display a menu of the DRB-II test categories for the anti-lock brake system. Press down arrow 3 times to view rest of menu.
- At this point, you have reached the ABS menu. At ABS menu of anti-lock brake system diagnostic program, specific test functions programmed into DRB-II cartridge can be performed. The following DRB-II modes can be accessed: SYSTEM TEST, READ FAULTS, STATE DISPLAY, ACTUATOR TEST and ADJUSTMENTS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
