Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
High Altitude Timing Control Function (3900 Ft. Or Higher And/Or Cold Engine)
With engine below normal operating temperature and/or above 3900 Ft. and idling, watch ignition timing. Apply battery voltage to ignition timing adjusting terminal No. 2, located in front left corner of engine compartment. Ensure timing retards from 15 degrees BTDC to 10 degrees BTDC. See Fig 1 . If timing does not change as specified, replace ignitor.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
