1989 Chrysler Conquest AutomaticFACTORY OEM SERVICE PROCEDURE

Remove, Overhaul & Install: Remove/Install/Overhaul: Introduction: Carburetor: Removal

Remove air cleaner. Disconnect engine coolant, vacuum, fuel and vapor hoses from carburetor. Disconnect throttle cable and automatic transmission kickdown cable (if equipped). Disconnect electrical connectors. Remove hold-down bolts and remove carburetor.

NOTE: DO NOT invert carburetor during disassembly. Do not remove choke valves, choke levers and related parts, round nut from accelerator pump link, adjusting screws (except idle speed, idle mixture and dashpot), or throttle valves.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.