1989 Chrysler Conquest AutomaticFACTORY OEM SERVICE PROCEDURE

Control Unit

NOTE: For ease of understanding, components are grouped into 2 categories. The first category, INPUT DEVICES, is components which control or produce voltage signals that are monitored by the ECU. The second category, OUTPUT DEVICES, are components that are controlled by the ECU (this is usually accomplished by the ECU grounding individual circuits).

The ECU receives and processes signals from data sensors and switches to control fuel delivery. The frequency and duration of injection (fuel delivery time) is controlled by ECU. Fuel delivery time is modified for such operating conditions as cold starting, altitude, acceleration and deceleration.

Chapter Navigation
Return to Chapter: Computerized Engine Controls
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.