1988 Chrysler New Yorker BaseFACTORY OEM SERVICE PROCEDURE

System Diagnosis

The throttle body fuel injection system is equipped with "On-Board Diagnosis," which has a self-diagnostic capability that checks several circuits. If abnormal signals occur often enough to indicate a valid problem, the SMEC will store the fault code for later display. If problem is either repaired or disappears by itself, the SMEC will remove the fault code after 50-100 engine starts.

Depending on fault code, the "Check Engine" light may illuminate. Located on instrument panel, this light informs operator that malfunction in system has occurred and immediate service is required.

The SMEC will attempt to compensate for failure of a component by using input from remaining sensors. If the check engine light comes on or certain driveability and engine performance problems exist, the source of these difficulties may be determined by displaying and recording fault codes. Check FAULT CODES to determine questionable circuits.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.