Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Chrysler New Yorker BaseFACTORY OEM SERVICE PROCEDURE
Displaying Fault Codes
- Connect Diagnostic Readout Box (C-4805) to diagnostic connector, located near the SMEC. If possible, start engine and cycle transmission selector and A/C switch (if equipped). Turn engine off.
- DO NOTΒ restart engine. Turn key on and off 3 times, completing sequence in 5 seconds. Record all fault codes as displayed by diagnostic readout box.
- If using "Check Engine" light for display, use same sequence to initiate display. "Check Engine" light will first illuminate for 3 seconds to check bulb. After bulb check, "Check Engine" light will display fault codes by series of flashes.
- There are short pauses between flashes and longer pauses between digits, with 4 second pause between codes. For example, fault Code 23 would be displayed by flash, flash, pause, flash, flash, flash. After 4 second pause, next numerically higher fault code will be displayed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
