1988 Chrysler New Yorker BaseFACTORY OEM SERVICE PROCEDURE

Single Module Engine Controller (SMEC)

The Single Module Engine Controller (SMEC), performs the functions formerly performed by the logic module and power module. The SMEC contains necessary circuits to operate the ignition coil, fuel injector, and alternator field. It computes the fuel injector pulse width, spark advance, ignition coil dwell, idle speed, purge, cooling fan operation and alternator charge rate. The SMEC contains a voltage converter which converts battery voltage to 8 volts output.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.