Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Chrysler Conquest AutomaticFACTORY OEM SERVICE PROCEDURE
Throttle Position Sensor
- Turn ignition switch to "OFF" position. Disconnect Throttle Position Sensor (TPS) connector. Using an ohmmeter, check resistance between terminals No. 1 and 3. See Figure . Resistance should be 3500-6500 ohms.
- Connect an ohmmeter across terminals No. 1 and 2. As throttle valve is slowly operated from closed to wide open throttle, check meter. Resistance should make a smooth transition from closed throttle to fully open position.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.