Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Chrysler Conquest AutomaticFACTORY OEM SERVICE PROCEDURE
Fuel Pressure
- Disconnect fuel pump harness connector located under rear seat or luggage compartment. Start engine. When engine stops by itself, turn ignition switch to "OFF" position. Disconnect negative battery cable and reconnect fuel pump harness connector.
- Cover high pressure hose from injecton mixer with rags and disconnect. Install a fuel pressure gauge on Adapter (MD998700) and attach between injection mixer and high pressure hose. See Fig 1 . Attach adapter to injection mixer with 2 screws supplied with adapter kit.
- Reconnect negative battery cable. Apply battery voltage to fuel pump terminal. Ensure fuel pressure gauge and adapter connection are not leaking. Measure fuel pressure when engine is at idle. Standard fuel pressure is 35-38 psi (2.4-2.6 Kg/cm2 ).
- If fuel pressure is lower than specification, problem could be clogged fuel strainer, defective pressure regulator or fuel pump. If fuel pressure is higher than specification, problem could be faulty pressure regulator or clogged fuel return hose.
- Stop engine and ensure fuel pressure does not drop. If fuel pressure drops slowly after engine is stopped, problem could be faulty injector. If fuel pressure drops immediately after engine is stopped, problem could be faulty fuel pump or pressure regulator.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
