1988 Chrysler Conquest AutomaticFACTORY OEM SERVICE PROCEDURE

Output Signal Chart Step 1

  1. Turn ignition switch to "LOCK" position. Remove large and small harness connector from ECU. On ECI Checker (MD998451 ), set check switch to "OFF" position and select switch to "A" position.
  2. Connect White connectors (labeled "CHECKER") of Harness Connector (MD998452 ) to ECI checker. Connect harness connector to ECU and body side harness connectors. See Figure . Perform checks according to appropriate ECI SYSTEM OUTPUT SIGNAL CHART-STEP 1.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.