1988 Chrysler Conquest AutomaticFACTORY OEM SERVICE PROCEDURE

Coolant Temperature Sensor

  1. Remove coolant temperature sensor from intake manifold and place end of sensor in water. Do not allow sensor to touch container. Terminal connector portion of sensor should be .12" (3 mm) above water.
  2. Gradually heat water and read resistance values at terminal connectors. Resistance should be as shown in COOLANT TEMPERATURE SENSOR RESISTANCE  table. If not, replace sensor.
COOLANT TEMPERATURE SENSOR RESISTANCE

Temperature °F (°C) Resistance (Ohms)
32 (0) 5900
68 (20) 2450
104 (40) 1100
176 (80) 300
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.