Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Chrysler Conquest AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Bleeder Cap | 14-22 (19-30) |
| Valve Cap | 22-29 (30-40) |
| Front Brake Caliper Bolts | 58-72 (78-97) |
| Front Wheel Bearing Nut | 14-0-4 (19-0-5) |
| Front Speed Sensor Bolts | 9-12 (12-16) |
| Rear Brake Caliper Bolts | 29-36 (39-49) |
| INCH Lbs. (N.m) | |
| Hydraulic Cylinder Screw | 48-84 (5-10) |
| Pulse Generator Clamp Bolt | 84-108 (10-12) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.