Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Chrysler Conquest AutomaticFACTORY OEM SERVICE PROCEDURE
"G" Sensor
- Turn ignition on. Connect a DVOM, between Green wire of "G" sensor and ground. Leave "G" sensor connected to wiring harness. When sensor is level, voltage should be 1.1-1.5 volts. Slowly rotate sensor 90 degrees. Voltage should be 4.6-5.0 volts. If sensor voltage is not to specification, replace "G" sensor.
- Ensure unlaiden vehicle is on a level surface. Using a spirit level, check levelness of sensor vertically and horizontally. Sensor must be within one degree. If sensor varies more than one degree, use shims to adjust within tolerance.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.