Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1987NEW YORKER 2.2 ELABOR TIMESTRANSMISSIONAUTOMATIC TRANSTRANSAXLE ASSEMBLYREMOVAL & INSTALLATION
1987 Chrysler New Yorker 2.2 E
Removal & Installation
1987 Chrysler New Yorker 2.2 ESECTION Removal & Installation
3 SPEED TRANS
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Automatic Trans,3 Spd Trans,Turbocharger,Trans Mfr CD A413 | 4.9 | 3.3 | C | |
| Combination Procedure: CLUTCH SEALS: Remove & Replace: | ||||
| Trans Mfr CD A413, Front & Rear | 1.1 | 1.1 | A | |
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| Trans Mfr CD A413 | 0.5 | 0.3 | C | |
| Combination Procedure: KICKDOWN BAND: Remove & Replace: | ||||
| Trans Mfr CD A413 | 0.9 | 0.9 | A | |
| Combination Procedure: OIL PUMP: Remove & Replace: | ||||
| Trans Mfr CD A413, Front | 0.6 | 0.6 | B | |
| Combination Procedure: REACTION SHAFT: Remove & Replace: | ||||
| Trans Mfr CD A413 | 0.6 | 0.6 | A | |
| Combination Procedure: REVERSE BAND: Remove & Replace: | ||||
| Trans Mfr CD A413 | 1.1 | 1.1 | A | |
| Combination Procedure: SPEEDOMETER DRIVE GEAR: Remove & Replace: | ||||
| Trans Mfr CD A413 | 1.5 | B | ||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| Trans Mfr CD A413 | 0.2 | 0.2 | C | |
| Combination Procedure: TRANSAXLE ASSEMBLY: Replace: | ||||
| Trans Mfr CD A413 | 0.6 | C | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.