Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1987FIFTH AVENUE 5.2 4LABOR TIMESTRANSMISSIONAUTOMATIC TRANSTRANSMISSION ASSEMBLYREMOVAL & INSTALLATION
1987 Chrysler Fifth Avenue 5.2 4
Removal & Installation
1987 Chrysler Fifth Avenue 5.2 4SECTION Removal & Installation
3 SPEED TRANS, TRANS ID - A727, A904, A904-LA, MA904, MA904A
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 3.1 | 2.3 | C | ||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.2 | C | |||
| Combination Procedure: INPUT SHAFT: Remove & Replace: | ||||
| 2.0 | A | |||
| Combination Procedure: KICKDOWN BAND: Remove & Replace: | ||||
| 2.0 | A | |||
| Combination Procedure: LOW & REVERSE SERVO BAND: Remove & Replace: | ||||
| 2.0 | A | |||
| Combination Procedure: OIL PUMP: Remove & Replace: | ||||
| Front | 0.4 | B | ||
| Combination Procedure: OIL PUMP HOUSING: Remove & Replace: | ||||
| Rear | 2.0 | B | ||
| Combination Procedure: OIL PUMP SEAL: Remove & Replace: | ||||
| Front | 0.2 | B | ||
| Combination Procedure: OUTPUT SHAFT: Remove & Replace: | ||||
| 2.4 | B | |||
| Combination Procedure: REACTION SHAFT &/OR BUSHING: Remove & Replace: | ||||
| 0.6 | A | |||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| 0.2 | C | |||
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: | ||||
| 0.6 | C | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.