Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Chrysler Conquest 2.6 H, AutomaticFACTORY OEM SERVICE PROCEDURE
All Others
- Disconnect Green-striped hose from injection mixer and connect vacuum pump to hose end. When engine is cold, 140°F (60°C) or less, and at idle, apply vacuum to hose. If idle does not change and vacuum leaks from EGR control solenoid valve, system is okay.
- When engine is hot, 185-205°F (85-95°C), and at idle, apply 2.4 in. Hg of vacuum. If idle does not change and vacuum holds, system is okay.
- Apply 6.8 in. Hg of vacuum. If idle becomes unstable or engine stalls (and vacuum holds), system is okay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.