Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Chrysler Laser XT, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Coolant Tube Nuts | 30 (41) |
| Exhaust Manifold Nuts | 16 (22) |
| Intake Manifold Bolts | 19 (26) |
| Oil Feed Line Tube Nuts | 10 (14) |
| Turbo-to-Exhaust Manifold Nuts | 40 (54) |
| Turbo Fuel Rail Screws | 21 (28) |
| Turbo Support Bracket Screws (Lower) | 40 (54) |
| Turbo Support Bracket Screws (Upper) | 20 (27) |
| INCH Lbs. (N.m) | |
| Turbo Heat Shield Screws | 9 (12) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.