Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Chrysler Laser XT, AutomaticFACTORY OEM SERVICE PROCEDURE
Removal & Installation: Precautions
- Before removing any fuel system components, displayed system pressure must be relieved.
- It is not necessary to remove throttle body from intake manifold to remove components.
- If fuel hoses are to be replaced, only hose marked EFI/EFM may be used. DO NOT use aviation style hose clamps as hose damage will occur.
- Always reassemble throttle body components with new "O" rings and seals where applicable. NEVER use lubricants on "O" rings or seals. If component assembly is difficult, use water to aid assembly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.