Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Chrysler Laser Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Jacking & Hoisting: Hoisting: Notes
CAUTION:
When removing rear axle, fuel tank, spare tire or lift gate on FWD vehicles and single post hoist is used, note the following: Anchor vehicle to hoist, place jack stands under vehicle or add weight on rear end of vehicle to prevent tipping when center of gravity changes.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
