1985 Chrysler Laser Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Fuel Regulator

On non-turbo models, the fuel regulator supplies fuel to the fuel injector at a constant 36 psi (2.5 kg/cm2 ) pressure. On turbo models, the regulator supplies fuel to the fuel rail and its four injectors at a constant 53 psi (3.7 kg/cm2 ) pressure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.