Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Chrysler Laser Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Pressure Test: Mechanical
- Disconnect fuel line from carburetor. Connect line to a pressure gauge. Hold gauge about 16" (406 mm) above pump level. Pinch off fuel return line (if equipped).
- Start engine and allow to idle (using gas in carburetor bowl). Observe pressure gauge. Pressure should be about 4-7 psi (.28-.49 kg/cm2 ) for 4 and 6 cylinder engines, and about 6-9 psi (.42-.63 kg/cm2 ) for V8 engines.
- Replace pump if pressure is too high or low, or if pressure varies greatly with the engine speed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.