Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1984 Chrysler Laser Base, 2.2 D, AutomaticFACTORY OEM SERVICE PROCEDURE
CCEGR Valve
- Remove CCEGR valve from vehicle. Place it in an ice bath to bring temperature of coolant sensing portion to below 40°F (4°C).
- Attach a hand vacuum pump with gauge to the CCEGR nipple corresponding to the Yellow stripe hose on 4-cylinder engines.
- Apply vacuum of 10 in Hg. Observe gauge for 1 minute. There should be no more than 1 in. Hg drop in vacuum within this time. If so, replace CCEGR valve.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.