1983 Chrysler ImperialFACTORY OEM SERVICE PROCEDURE

Ignition System - V8: Description: Notes

The Electronic Spark Control (ESC) system is governed by a Spark Control Computer, 7 engine sensors, a specially-calibrated carburetor and, on most models, a dual pick-up distributor. Models with the 5.2L EFI (Electronic Fuel Injection) engine have a single pick-up distributor. The ESC system is designed to burn a lean air/fuel mixture, with a minimum of emissions. See Figure.

NOTE: For a diagram of 10-wire and 12-wire connectors for the ignition and electronic fuel injection systems of 5.2L EFI, see Chrysler Electronic Fuel Injection Articles in FUEL SYSTEMS section.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.