1982 Chrysler ImperialFACTORY OEM SERVICE PROCEDURE

Electronic Servomotor

Located on the evaporator-heater assembly above blend air door shaft. Measures resistance of in car sensor, ambient sensor and control head resistor and moves blend-air door to a position which relates to certain electrical resistance. High sensor or control head resistances cause servomotor to move blend-air door to a higher heat position.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.