Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Chrysler ImperialFACTORY OEM SERVICE PROCEDURE
Spark Advance of Computer
- Start engine and allow it to warm to normal operating temperature. Put transmission in neutral and set parking brake.NOTE: The Spark Control Computer has various spark advance schedules incorporated into its microprocessor for operation at differing engine temperatures. Therefore, be sure engine is at normal operating temperature before testing.
- Place a thin insulator (piece of paper) between curb idle adjusting screw and carburetor switch, or make sure screw is not touching switch. See Figure. Remove and plug vacuum line at vacuum transducer.
- Connect an auxiliary vacuum supply to vacuum transducer and set for 16 in. Hg vacuum. Increase engine speed to 2000 RPM, wait one minute for specified accumulator clock up time, and then check specifications. Advance specifications are in addition to basic advance.CAUTION: Use a metal exhaust tube for this test, as high temperatures could cause rubber hose to catch fire.
- If computer fails to obtain specified settings, replace computer.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.