Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Chrysler ImperialFACTORY OEM SERVICE PROCEDURE
Basic Advance Timing Test
- Connect an adjustable timing light to engine so that total timing advance at crankshaft can be checked. Connect a jumper wire between carburetor switch and a good ground.
- Be sure vacuum line is connected to vacuum transducer on computer. Observe timing mark immediately after engine starts to run, and adjust timing light so basic timing signal is seen at timing plate.
- The meter on timing light should then show amount of advance, as indicated on vehicle emission control label.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.