Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Chrysler ImperialFACTORY OEM SERVICE PROCEDURE
Motor And Linkage: Notes
- Place wiper switch in "LOW" position. If motor can be heard running, check output shaft. If shaft is not turning, replace gearbox. If shaft is turning, check wiper linkage.
- Connect a voltmeter to terminal "L" at motor with switch in "LOW". If voltage present and motor not running, connect jumper from "P2" to ground. If motor runs, switch or wiring is faulty. If not, check motor brushes and armature.
- If voltage is present intermittently, check for short circuits in motor, wiring, and switch. Disconnect wiring at motor and remove wiper arms. Connect an ammeter between battery and terminal "L", and a jumper between "P2" and ground. If motor runs and current draw is less than 6 amps, problem is in switch and wiring.
- If motor does not run or current draw is more than 6 amps, disconnect motor from linkage. If motor now runs and current draw is less than 3 amps, fix linkage. If motor does not run or draws more than 3 amps, repair or replace gearbox and motor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
