Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2025 Chevrolet Trax LSFACTORY OEM SERVICE PROCEDURE
Installation Procedure
Keyless Entry Control Module (1) - Install
- Connect the electrical connectors.
Front Floor Console Extension Panel - Right Side (1) - Install
Front Floor Console Extension Panel - Left Side (2) - Install
- Front Floor Console Extension Panel Bolt (1) - Install and tighten - Fastener Specifications
- Return the seat to its original position.
- Perform the necessary programming and setup procedure: Control Module References
CAUTION:
Refer to Fastener Caution .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.