Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Adding NFC Cards
To add Key Cards, perform the following procedure:
- The vehicle is capable of learning a total of 8 key cards.
- Connect a scan tool to the vehicle and access SPS.
- Select the SPS application and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K183 UHF Short Range Low Energy Remote Control Access Transceiver.
- Select Key Card Learn.
- Select the Add Card function.
- Refer to the owners manual or the key card for key card reader location.
- Follow the on-screen instructions.
- With a scan tool, clear any DTCs.
- Verify each card that was programmed is operating properly. Ensure the card locks or unlocks the vehicle.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.