Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Chevrolet Traverse LS, FWDFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
Electric Belt Drive Rack and Pinion Steering Gear
| Callout | Component Name [Component Quantity] | Single Use Fastener / Component | Thread Locking Adhesive Required | Specification | Procedure |
|---|---|---|---|---|---|
| Metric (English) | |||||
| 1 | Steering Gear Boot Inner Clamp [2x] | Yes | - | - | Steering Gear Boot Replacement |
| 2 | Steering Gear Bolt | - | - | 100 N.m (74 lb ft) | Electric Belt Drive Rack and Pinion Steering Gear Replacement |
| 3 | Steering Gear Bolt [2x] | - | - | First Pass: 100 N.m (74 lb ft) Final Pass: (45 - 60) degrees |
Electric Belt Drive Rack and Pinion Steering Gear Replacement |
Steering Linkage
| Callout | Component Name [Component Quantity] | Single Use Fastener / Component | Thread Locking Adhesive Required | Specification | Procedure |
|---|---|---|---|---|---|
| Metric (English) | |||||
| 1 | Steering Linkage Inner Tie Rod | - | - | 100 N.m (74 lb ft) | Steering Linkage Inner Tie Rod Replacement |
| 2 | Steering Linkage Outer Tie Rod Nut | - | - | First Pass: 35 N.m (26 lb ft) Final Pass: (90 - 100) degrees |
Steering Linkage Outer Tie Rod Replacement |
Steering Gear Heat Shield
| Callout | Component Name [Component Quantity] | Single Use Fastener / Component | Thread Locking Adhesive Required | Specification | Procedure |
|---|---|---|---|---|---|
| Metric (English) | |||||
| 1 | Steering Gear Heat Shield Bolt | - | - | 10 N.m (89 lb in) | Power Steering Assist Motor Replacement |
Power Steering Assist Motor
| Callout | Component Name [Component Quantity] | Single Use Fastener / Component | Thread Locking Adhesive Required | Specification | Procedure |
|---|---|---|---|---|---|
| Metric (English) | |||||
| 1 | Steering Gear Housing Cover Bolt [6x] | Yes | - | 25 N.m (18 lb ft) | Power Steering Assist Motor Replacement |
Power Steering Assist Motor
| Callout | Component Name [Component Quantity] | Single Use Fastener / Component | Thread Locking Adhesive Required | Specification | Procedure |
|---|---|---|---|---|---|
| Metric (English) | |||||
| 1 | Power Steering Assist Motor Pivot Bolt [3x] | Yes | - | 10 N.m (89 lb in) | Power Steering Assist Motor Replacement |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.