Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Chevrolet Traverse LS, FWDFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Disable the SIR system. SIR Disabling and Enabling
- NOTE:
Left side shown, right side similar.
Body Rear Corner Upper Garnish Molding Cap - Right Side (1) - Remove
- Body Rear Corner Upper Garnish Molding Bolt- Right Side (2) - Remove
- Body Rear Corner Upper Garnish Molding- Right Side (3) - Reposition
Quarter Lower Rear Trim Panel- Right Side (1) - Reposition
Disconnect the electrical connectors.
- Release the retaining tabs.
- Remote Function Actuator Module (1) - Remove
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.