Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
With the aid of an assistant, remove the fascia. (1) - Rear Bumper Fascia Removal and Installation (1LT / 2LT / 3LT) , or Rear Bumper Fascia Removal and Installation (T0F / T0G) , or Rear Bumper Fascia Removal and Installation (T0E)
Rear End Trim Cover Panel (3) Remove - Rear End Trim Cover Panel Replacement
Use a grease pencil to mark the original location of the rear compartment lid latch (2).
- Disconnect the electrical connector.
- Liftgate Latch Nut (1) - Remove [4x]
- Rear Compartment Lid Latch (2) - Remove
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.