2021 Chevrolet Traverse LFACTORY OEM SERVICE PROCEDURE

Steering Gear Boot Replacement

GM4742194Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Steering Linkage Outer Tie Rod Replacement 
1 Steering Linkage Inner Tie Rod Nut
Procedure 
Place match marks on the steering linkage inner tie rod nut and the steering linkage inner tie rod.
2 Steering Gear Boot Outer Clamp
3 Steering Gear Boot Inner Clamp

Procedure

  1. Cut the steering gear boot inner clamp.

    DISCARD the clamp.

  2. Use the DT-35910  pliers to install the NEW steering gear boot inner clamp.
NOTE:

Position the NEW steering gear boot inner clamp on the steering gear boot before installing the boot on the steering gear.


Special Tools 
DT-35910  Drive Axle Boot Clamp Pliers
Equivalent regional tools: Special Tools 
4 Steering Gear Boot

Procedure

  1. After removing the steering gear boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination. If corrosion or contamination is evident, replace the steering gear. Electric Belt Drive Rack and Pinion Steering Gear Replacement 
  2. Install the steering gear boot and ensure the boot is seated in the assembly groove of the steering gear before installing the steering gear boot clamps.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.