Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
- NOTE:
Use a small flat-bladed tool to disengage integral tabs on caro tie down loop bolt cap
Cargo Tie Down Loop Bolt Cap (1) - Remove [2x]
- Cargo Tie Down Loop Bolt (2) - Remove [2x]
- Cargo Tie Down Loop (3) - Remove [2x]
Rear Compartment Floor Panel Trim (1) - Remove
Use a small flat-bladed tool to disengage integral tabs on rear end trim finish panel opening cover (1).
- Rear End Trim Finish Panel Opening Cover (1) - Remove
With a flat bladed plastic trim tool, disengage the integral clips.
- Rear End Trim Finish Panel (1) - Remove
- NOTE:
Carefully manipulate the deck lid hinge opening of the rear compartment side trim past the hinge cover.
Rear Compartment Side Trim Insulator Retainer (1) - Remove [4x]
- Rear Compartment Side Trim-Left Side (2) - Reposition
Electrical Connector (1) @ Electronic Suspension Control Module - Disconnect
- Disconnect the wiring harness retainers and reposition the harness as necessary.
Release the retaining tab (2) and slide the electronic suspension control module (1) out of the rear body fuse block bracket.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
