2021 Chevrolet Traverse LFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5509253Courtesy of GENERAL MOTORS COMPANY

    Slide the electronic suspension control module (1) into the rear body fuse block bracket until the retaining tab (2) is engaged.

  2. Reposition the wiring harness and connect the wiring harness retainers.
  3. GM5509250Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (1) @ Electronic Suspension Control Module - Connect

  4. GM5483561Courtesy of GENERAL MOTORS COMPANY

    Rear Compartment Side Trim-Left Side (2) - Install

  5. Rear Compartment Side Trim Insulator Retainer (1) - Install [4x]
  6. GM5465255Courtesy of GENERAL MOTORS COMPANY

    Rear End Trim Finish Panel (1) - Install

  7. GM5459293Courtesy of GENERAL MOTORS COMPANY

    Rear End Trim Finish Panel Opening Cover (1) - Install

  8. GM5471799Courtesy of GENERAL MOTORS COMPANY

    Rear Compartment Floor Panel Trim (1) - Install

  9. GM5459270Courtesy of GENERAL MOTORS COMPANY

    Cargo Tie Down Loop (3) - Install [2x]

  10. CAUTION:

    Refer to Fastener Caution .

  11. Cargo Tie Down Loop Bolt (2) - Install and tighten [2x] - Fastener Specifications
  12. Cargo Tie Down Loop Bolt Cap (1) - Install [2x]
  13. Perform the necessary programming and setup procedure:Control Module References
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.