2021 Chevrolet Traverse LFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5509330Courtesy of GENERAL MOTORS COMPANY

    Ignition Lock Key Transmitter Antenna Bracket (1) - Install

  2. GM5484133Courtesy of GENERAL MOTORS COMPANY

    Install the low frequency body side antenna (1) and secure the 2 retainer tabs.

  3. Connect the electrical connector.
  4. GM5437586Courtesy of GENERAL MOTORS COMPANY

    Position the rocker panel molding (2) to the vehicle and seat the upper rocker panel molding retainers (1) into the body side outer panel.

  5. Seat the lower rocker panel molding retainers (1) into the body side outer panel.
  6. GM5437585Courtesy of GENERAL MOTORS COMPANY

    Position the rear wheelhouse liner (3) to its original location.

  7. Rear Wheelhouse Liner Retainer (2) Install
  8. CAUTION:

    Refer to Fastener Caution .

  9. Rear Tire Front Air Deflector Bolt (1) - Install and tighten - Fastener Specifications
  10. GM5437584Courtesy of GENERAL MOTORS COMPANY

    Position the front wheelhouse liner (2) to its original location.

  11. Front Wheelhouse Liner Retainer (1) - Install
  12. Close both front and rear side doors.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.