2021 Chevrolet Traverse LFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5475541Courtesy of GENERAL MOTORS COMPANY

    Ensure the retaining tabs are properly aligned.

  2. Image Processing Module (1) - Install
  3. GM5475540Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connectors.

  4. Secure the retaining tab.
  5. GM5482696Courtesy of GENERAL MOTORS COMPANY

    Rear Window Panel Trim (2) Install

    • With the aid of an assistant, guide the rear window panel trim (1) rearward in the vehicle and downward to clear the speaker system.
    • Ensure the rear window trim panel feet are seated into the rear window sheet metal drain shoe.
  6. Rear Window Panel Trim Retainer (1) - Install [ 3x ]
  7. GM5474407Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector.

  8. Quarter Upper Trim Panel (3) - Install [ 2x ]
    9. CAUTION:

    Refer to Fastener Caution .

  9. Quarter Window Trim Finish Panel Bolt (2) Install and tighten [ 2x ] - Fastener Specifications
  10. Quarter Window Trim Finish Panel Bolt Cap - Install [ 2x ]
  11. Enable the SIR System. SIR Disabling and Enabling .
  12. Perform the necessary programming and setup procedure:Control Module References
Chapter Navigation
Return to Chapter: Image Processing Module Replacement
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.