2021 Chevrolet Traverse LFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5488339Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector.

  2. Wireless Charging System Module (2) - Install
    3. CAUTION:

    Refer to Fastener Caution .

  3. Wireless Charging System Module Bolt (1) - Install and tighten [ 4x ] - Fastener Specifications 
  4. GM5502706Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector.

  5. Front Floor Console Trim Plate (1) - Install
  6. GM5502705Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Trim Plate Bolt (2) - Install and tighten [ 2x ] - Fastener Specifications

  7. Front Floor Console Variable 1 Liner (1) - Install
  8. GM5482681Courtesy of GENERAL MOTORS COMPANY

    Slide the front floor console (1) back into the instrument panel.

  9. GM5643539Courtesy of GENERAL MOTORS COMPANY

    Connect the front floor console harness connector (1).

  10. GM5482680Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Bolt (1) - Install and tighten [ 6x ] - Fastener Specifications

  11. Front Floor Console Bracket Bolt (2) - Install and tighten [ 2x ] - Fastener Specifications
  12. GM5479956Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Extension Panel - Right Side (1) - Install

  13. Return the seat to its original position.
  14. GM5479957Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Extension Panel - Left Side (1) - Install

  15. Return the seat to its original position.
  16. Perform the necessary programming and setup procedure:Control Module References
Chapter Navigation
Return to Chapter: Wireless Charging System Module Replacement (MQA)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.