Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
Reposition the seat as necessary to access the retaining clips.
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Extension Panel - Left Side (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Extension Panel - Right Side (1) - Remove
Front Floor Console Bolt (1) - Remove [ 6x ]
- Front Floor Console Bracket Bolt (2) - Remove [ 2x ]
- Release the tabs (3) on both sides of the front floor console.
Slide the front floor console (1) enough to clear the instrument panel lower center trim panel.
Front Floor Console Variable 1 Liner (1) - Remove
- Use a plastic trim tool to release the transmission control lever boot (2) from the front floor console trim plate.
- Disconnect the electrical connector (3).
- Front Floor Console Trim Plate Bolt (4) - Remove [ 2x ]
Remove the automatic transmission control lever knob (1) by pulling up and releasing the retainer.
Front Floor Console Trim Plate (1) - Remove
Automatic Transmission Range Selector Lever Cable Bolt (1) - Remove
- Automatic Transmission Range Selector Lever Cable (2) - Release
- Disconnect the front floor console wiring harness (3) from the body wiring harness.
Wireless Charging System Module Bolt (1) - Remove [ 4x ]
- Wireless Charging System Module (2) - Remove
- Disconnect the electrical connector.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
