2021 Chevrolet Traverse LFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5488339Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector.

  2. Wireless Charging System Module (2) - Install
  3. CAUTION:

    Refer to Fastener Caution .

  4. Wireless Charging System Module Bolt (1) - Install and tighten [ 4x ] - Fastener SpecificationsΒ 
  5. GM5488424Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Range Selector Lever Cable Bolt (1) - Install and tighten - Fastener Specifications

  6. Automatic Transmission Range Selector Lever Cable (2) - Install and tighten - Fastener Specifications
  7. Connect the front floor console wiring harness (3) to the body wiring harness.
  8. GM5487916Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Trim Plate (1) - Install

  9. GM5644700Courtesy of GENERAL MOTORS COMPANY

    Install the automatic transmission control lever knob (1) then press down to engage the retainer.

  10. Carefully pull upward on the automatic transmission control lever knob (1) to ensure that the retainer is engaged.
  11. GM5487915Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Trim Plate Bolt (4) - Install and tighten [ 2x ] - Fastener Specifications

  12. Connect the electrical connector (3).
  13. Insert the transmission control lever boot (2) into the front floor console trim plate.
  14. Shift the transmission through each gear and ensure that the shift lever knob operates properly.
  15. Front Floor Console Variable 1 Liner (1) - Install
  16. GM5482681Courtesy of GENERAL MOTORS COMPANY

    Slide the front floor console (1) back into the instrument panel.

  17. GM5482680Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Bolt (1) - Install and tighten [ 6x ] - Fastener Specifications

  18. Front Floor Console Bracket Bolt (2) - Install and tighten [ 2x ] - Fastener Specifications
  19. GM5479956Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Extension Panel - Right Side (1) - Install

  20. Return the seat to its original position.
  21. GM5479957Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Extension Panel - Left Side (1) - Install

  22. Return the seat to its original position.
  23. Perform the necessary programming and setup procedure:Control Module References
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.