Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Chevrolet Trailblazer LFACTORY OEM SERVICE PROCEDURE
Valve Timing Control Assembly: Remove & Replace
NOTE: Labor estimates listed are for R&R only and DOES NOT include diagnosis time.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 1.2L Eng, Camshaft Position Actuator,Both,Intake & Exhaust | Includes: R&I Camshaft Cover w/Turbocharger together as an assembly. Includes: R&I Catalytic Converter. Includes: R&I Starter Assembly. Includes: R&I Fender Liner. Includes: R&I Timing Cover. Includes: Drain and refill Cooling System. Includes: Drain and refill Engine Oil. Includes: Reset Oil Life Monitor. | 8.8 | B | |
| 1.2L Eng, Camshaft Position Actuator,One,Intake or Exhaust | Includes: R&I Camshaft Cover w/Turbocharger together as an assembly. Includes: R&I Catalytic Converter. Includes: R&I Starter Assembly. Includes: R&I Fender Liner. Includes: R&I Timing Cover. Includes: Drain and refill Cooling System. Includes: Drain and refill Engine Oil. Includes: Reset Oil Life Monitor. | 8.7 | 3.5 | B |
| Combination Procedure: AIR INTAKE SYSTEM: Reset: | ||||
| 1.2L Eng, Intake System Learned Values Reset | Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.