Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Wireless Charging System Module (2) - Install
- Wireless Charging System Module Bracket Bolt (1) - Install and tighten [4x] - Fastener Specifications
Connect the electrical connectors.
- Front Floor Console Cup Holder Trim Plate (1) - Install
Front Floor Console Stowage Tray (1) - Install
Front Floor Console Armrest Pivot Pin (1) - Install
- Front Floor Console Storage Tray Bolt (2) - Install and tighten [2x] - Fastener Specifications
Front Floor Console Storage Tray Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Front Floor Console Armrest Hinge Clip (2) - Install
Connect and position the wiring harness.
- Front Floor Rear Console Side Trim Panel (1) - Install
Front Floor Console Bolt Access Hole Cover (1) - Install
Front Floor Console Extension Panel (1) - Install
Front Floor Console Applique (1) - Install
Front Floor Console Lower Applique (1) - Install
Front Floor Rear Console Side Trim Panel (1) - Install
Front Floor Console Rear Trim Lower Panel (1) - Install
Front Floor Console Bolt Access Hole Cover (1) - Install
Front Floor Console Extension Panel (3) - Install
- Front Floor Console Extension Bolt (2) - Install and tighten - Fastener Specifications
- Front Floor Console Extension Panel Bolt Access Hole Cover (1) - Install
Front Floor Console Applique (1) - Install
Front Floor Console Lower Applique (1) - Install
- Return the armrest compartment to the close position.
- NOTE:
Left side shown, right side similar.
Front Seat- Left Side and Right Side (2) - Install [2x] - Front Seat Removal and Installation
Refer to Fastener Caution .
Refer to Fastener Caution .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.