2021 Chevrolet Tahoe SSVFACTORY OEM SERVICE PROCEDURE

Coolant Temperature Sensor: Remove & Replace

WARNING: This page is about the Tahoe High Country, 3.0L Eng VIN T, 4WD, which is a different variant/trim than selected.

FUEL INJECTION - ELECTRONIC, DIESEL

Applies ToNoteStandard HoursWarranty HoursSkill Level
3.0L Eng, At Charge Air Cooler Coolant HoseIncludes: Drain and Refill Coolant Turbocharger System.0.90.7B
3.0L Eng, At Engine Block,Both,Front & RearIncludes: Drain and refill Cooling System. Includes: R&I Fender Liner.1.4B
3.0L Eng, At Engine Block,One,Front or RearIncludes: Drain and refill Cooling System. Includes: R&I Fender Liner.1.30.8B
3.0L Eng, At RadiatorIncludes: Drain and refill Cooling System.1.10.7B
3.0L Eng, At Water Pump Inlet Pipe,w/Air SuspensionIncludes: Drain and refill Cooling System. Includes: R&I Fender Liner.1.81.1B
3.0L Eng, At Water Pump Inlet Pipe,w/o Air SuspensionIncludes: Drain and refill Cooling System. Includes: R&I Fender Liner.1.71.1B
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.