Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fastener Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Evaporative Emission Canister Purge Solenoid Valve O-ring Seal |
| Fuel Injector Dust Seal |
| Fuel Injector Retainer |
| Fuel Injector Seal |
| Fuel Pressure Sensor O-ring |
| Fuel Pump Gasket |
| Throttle Body Seal |
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Fuel Feed Intermediate Pipe Fitting | 28 N.m (21 lb ft) |
| Fuel Injection Fuel Rail Fuel Pressure Sensor | 32.5 N.m (24 lb ft) |
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Accelerator Pedal Bracket Bolt | 9 N.m (80 lb in) |
| Air Cleaner Access Cover Bolt | 2.5 N.m (22 lb in) |
| Air Cleaner Bolt | 9 N.m (80 lb in) |
| Air Cleaner Outlet Duct Clamp | 3.5 N.m (31 lb in) |
| Auxiliary Fuel Tank Shield Bolt | 9 N.m (80 lb in) |
| Camshaft Position Sensor Bracket Bolt | 8.5 N.m (75 lb in) |
| Crankshaft Position Sensor Bolt | 25 N.m (18 lb ft) |
| Engine Control Module Bracket Brace Bolt | 9 N.m (80 lb in) |
| Engine Oil Pressure Sensor | 35 N.m (26 lb ft) |
| Engine Oil Temperature Sensor | 20 N.m (15 lb ft) |
| Engine Coolant Temperature Sensor | 28 N.m (21 lb ft) |
| Evaporative Emission Canister Purge Solenoid Valve Bolt | 10 N.m (89 lb in) |
| Front Intake Air Duct Cover Retainer | 2.5 N.m (22 lb in) |
| Fuel Feed Front Hose Clip Bolt | 9 N.m (80 lb in) |
| Fuel Feed Front Pipe Clip Bolt | 22 N.m (16 lb ft) |
| Fuel Feed Pipe Bolt | 10 N.m (89 lb in) |
| Fuel Injection Fuel Rail Bolt | 25 N.m (18 lb ft) |
| Fuel Pump Bolt | 25 N.m (18 lb ft) |
| Fuel Pump Power Control Module Nut | 9 N.m (80 lb in) |
| Fuel Tank Filler Hose Clamp | 4.5 N.m (40 lb in) |
| Fuel Tank Filler Pipe Ground Bolt | 22 N.m (16 lb ft) |
| Fuel Tank Strap Bolt | 22 N.m (16 lb ft) |
| Fuel Tank Vent Pipe Clip Bolt | 9 N.m (80 lb in) |
| Heated Oxygen Sensor | 42 N.m (31 lb ft) |
| Ignition Coil Bolt | 5 N.m (44 lb in) |
| Ignition Coil Bracket Bolt-Bracket | 25 N.m (18 lb ft) |
| Ignition Coil Bracket Bolt- Wire | 5 N.m (44 lb in) |
| Intake Air Duct Bolt | 9 N.m (80 lb in) |
| Knock Sensor Bolt | 25 N.m (18 lb ft) |
| Manifold Absolute Pressure Sensor Bolt | 4.5 N.m (40 lb in) |
| Mass Airflow Sensor Bolt | 2.5 N.m (22 lb in) |
| Spark Plug | 20 N.m (15 lb ft) |
| Throttle Body Bolt | 10 N.m (89 lb in) |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.