Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fastener Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Catalytic Converter Gasket |
| Exhaust Manifold Gasket |
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Exhaust Manifold Bolt | |
| First Pass: | 27 N.m (20 lb ft) |
| Second Pass: | loosen 180 degrees |
| Final Pass: | 23 N.m (17 lb ft) |
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Catalytic Converter Brace Bolt | 22 N.m (16 lb ft) |
| Catalytic Converter Heat Shield Bolt | 10 N.m (89 lb in) |
| Catalytic Converter Nut | 58 N.m (43 lb ft) |
| Exhaust Control Valve Actuator Bolt | 10 N.m (89 lb in) |
| Exhaust Hanger Bracket Bolt | 22 N.m (16 lb ft) |
| Exhaust Heat Shield Bolt | 8 N.m (71 lb in) |
| Exhaust Heat Shield Bolt With GPF |
10 N.m (89 lb in) |
| Exhaust Manifold Heat Shield Bolt | 10 N.m (89 lb in) |
| Exhaust System Rear Nut | 22 N.m (16 lb ft) |
| Exhaust System Washer | 1.5 N.m (13 lb in) |
| Exhaust Muffler Hanger Bracket Bolt | 22 N.m (16 lb ft) |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.